Jack Puck 8 Ton Pollen Press

Description

The mold is dismountable, allowing it to be warmed up in the oven to improve its effectiveness. Equipped with a 2 ton or 8 ton load capacity hydraulic jack, JACK PUCKS are light and compact presses easy to carry.

Jack Puck Presses, made by Makametal, are industrial grade pollen presses made from stainless steel that can compact plant extracts into a puck or brick. These presses take plant extracts and compact them into a paste or brick by removing all the excess water leaving, you with the essence of the plant. These presses are compact, but pack extreme pressing power for your extracting needs.

When most hobbyists think about making paste discs or squares out of their favorite plant extracts, their mind usually turns to thoughts of cheap and flimsy aluminum pollen presses that you buy at your local head shop for less than $20. These usually work by compressing plant extracts with tedious turning and twisting of the compressor on the device. This process usually requires some gloves and lots of elbow grease. The end result is a basic pollen press that will give you three or four below-average uses.

What makes The Jack Puck Press Special?

Jack Puck presses take a different approach to pollen pressing. The Jack Puck press is available in two different heavy-duty sizes (2 Ton and 8 Ton) and three different mold shapes (regular round, small round and square). This means users have a great variety of choice in terms of processing power, size and shape. Adding to the versatility of this state-of-the-art pollen press, the 2 Ton Jack Puck Press allows for the dismount and interchange of molds. This means that you can use any of the three molds on the same press – to your heart’s content.

The Jack Puck works using a hydraulic jack to deliver maximum pressure with minimal effort to yield consistent results. The system works similar to a jack used to change a car tire. With a simple up and down movement of the steel lever, the press activates the hydraulic compressor at the base of the Jack Puck mold. This process is as easy as adding your plant extracts to the mold, sealing the chamber, then compressing the paste. To make the process even more effective, the manufacturer recommends heating the mold and its base in an oven prior to use.

• Equipped with a 8 ton load capacity hydraulic jack
• Dismountable mould – allowing it to be warmed up in the oven to improve its effectiveness.
• Light & Compact – Easy to carry
• Dimensions: 7″ x 8″ x 14.75″